AIM Solo 2 DL : Lap Timer / Data Logger

Solo 2 DL : Data Logger (just like the SOLO but with ECU connection) the most precise and easy way to get lap times. The new Solo 2 receives the data from two satellites constellations, GPS and Glonass: this is a huge step forward since it is unbelievably faster and more precise than the previous version and the lap times are calculated within a maximum gap not higher than 2/100 sec.

Solo 2 DL, the Solo with ECU connection
More than 1,000 protocols for 1,000+ ECU in the database, for easily connect your Solo 2 DL to your Engine Control Unit and get a lot of information with just one cable. In case your ECU protocol is not in the database, no problem: an ECU Driver Builder is always available in the Race Studio 3 configuration software, and you will be able to create your protocol by yourself.

Coil RPM input
Solo 2 DL now features a digital input allowing to log RPM either from square wave signals (8-50 V signal) or pulse signals (150-450 V ignition coil trigger - primary circuit).

Find your track easily and quickly
Solo 2 can rely on a database of more than 2,000 tracks all over the world: as soon as it switches on, Solo 2 identifies its position, recognizes the starting line coordinates of the track and starts sampling lap times.

Configurable RGB LEDs
Even the predictive lap time is much more reliable, and the configurable RGB LEDs will give you the time gap compared to the best lap you set as reference.

Race mode selection Solo 2 can manage two types of races:

• Speed races in a closed circuit
• Performance tests (0-100 km/h etc.)
• In each of these configurations,
• Solo 2 gives the proper information
• during the test and powerful data
• review immediately after each session.

Data recall on screen
At the end of your test, you can quickly review all the key information on your display.